AUTOMATIC (water) ACTIVATION:
The Stormy optional water activated system will inflate automatically within 5 seconds on immersion in water.

MANUAL INFLATION:
Grasp the top or side of the velcro attached inflation pocket and tear the pocket down and off. This action will trigger the CO2 gas cylinder inflating your PFD instantly giving you buoyancy to PFD Type 1 standard. Replace the used CO2 cylinder at your earliest opportunity. If you need advice as to how to do this or where to obtain a cylinder please contact Stormy Australia.

ORAL INFLATION:
Should you find yourself in a hazardous (but not an emergency) situation, you can inflate your Stormy PFD orally. Pull down the inflation pocket about halfway and take out the red oral inflation tube located next to the gas cylinder and inflate by mouth.

TO DEFLATE:
Invert the black inflation cap and press the raised top of the cap into the oral inflation tube. This will open the one-way valve.

AFTER ACTIVATION:
When the trigger mechanism has activated (Jacket inflated) it is necessary to replace the CO2 cylinder and the Bobbin. Remove the old cylinder by unscrewing anticlockwise. Unscrew the clear end cap and remove the old bobbin. Discard the old bobbin. To install a new bobbin - ensure fittings are dry before placing bobbin in trigger mechanism (fits only with white side down). Replace clear end cap by hand screwing firmly home in a clockwise direction.

NOTE: When an unused bobbin is in place a green indicator will show in bottom of clear end cap. A red indicator will show if a used bobbin is installed. Do not install end cap without bobbin in place because the CO2 cylinder will be punctured as the cap is screwed home.

Install CO2 cylinder in top of mechanism and firmly hand tighten in a clockwise direction. Fit green indicator tab through hole in trigger mechanism and manual activation lever.